Video: Compensating for a Bad Center Hole
Center hole drilled off-center? A compensating live center can save parts from becoming scrap.
.jpg;width=70;height=70;mode=crop;format=webp)
Share
A center hole that is drilled even slightly off-center can lead to a non-concentric workpiece. If no adjustments are made and the runout is too much, that workpiece ultimately ends up as scrap. While a bad center hole may be only an occasional problem, it can be fairly simple to correct with the use of a compensating live center.
The video above from demonstrates how its Adjusta-Point live center is able to offset a shaft’s deviation by means of external adjusting screws. The adjustment process is similar to indicating a part using a four-jaw chuck, and it takes only a few minutes to bring the shaft back within acceptable grinding standards.
Related Content
-
Rail Manufacturer Moves Full Steam Ahead with Safe, Efficient Workholding Solution
All World Machinery Supply paired a hydraulic power unit with remote operating capabilities in a custom workholding system for Ahaus Tool & Engineering.
-
Using Jaws as Grippers Enables Flexible, Low-Cost Automation
VersaBuilt’s automation systems significantly boosted Innovative Fabrication’s revenue. In return, the shop has helped VersaBuilt optimize its products.
-
Medical Shop Performs Lights-Out Production in Five-Axes
Moving to five-axis machining enabled this shop to dramatically reduce setup time and increase lights-out capacity, but success relied on the right combination of workholding and automation.